Fiberglass Refinishing and Inlay
Repair system for PBRA members only
If the floor of your fiberglass
shower unit has developed cracks. Or if leaking has occurred
because of those cracks, an inlay can be installed that will fix
that problem. When a Fiberglass shower unit is installed in a home
during construction, it is attached to the surrounding 2x4 wall
studs, and supported underneath with a frame built also using
2x4's. Over time, the floor of the shower may weaken, if the floor
supports are too far apart. Surface cracks may develop on the edges
of the supports, or an actual break may occur in the floor causing
water to leak to rooms below.
The
solution: Custom fit Floor Inlay.
Visual inspection by a PBRA technician is
necessary, at which time measurements will be taken to ensure a
proper fit. The inlay is installed using a two-component epoxy glue
that "welds" itself to the surface of the shower unit. The surface
will never leak again, it will never crack, and your floor will be
stronger than before. The custom Inlay system exclusively available
to PBRA members only. So whether your just updating colors or wish
to salvage a cracked fiberglass unit then the PBRA has a refinishing
and repair system for you.
Back to
Refinishing
