MELT DOWN GLOSS ENHANCER & REPAIR BLENDER

MELT DOWN GLOSS ENHANCER & REPAIR BLENDER
Click over image to enlarge
Price: $89.00
 
Weight: 10.00 lbs
Purchase
Quantity :
 
Overview
GLOSS ENHANCER - BLENDER - MELT ORANGE PEEL
Description

Melt Down has FOUR important uses for bathtub, tile and counter top refinishers. 

  • Elminates return return trips for buffing
  • Eliminates return return trips for orange peel
  • Eliminates dry edge (halo)
  • Increases Gloss 10 - 15 %
  • Increases Depth of Gloss 

 

1. Repairs Instructions: " BURNING  THE HALO". Melt Down edge repair blender eliminates buffing on return visits to blend edge repairs. Once the repair is made and sprayed. Allow to dry 3-5 Minutes then lighly mist Melt down repair blender on the outer endges of the repair using your hvlp spray gun, air brush, or preval  sprayer,

 

2. Melts Orange Peel: During the refinishing process you may notice unusual "ORANGE PEEL".  Just prior to spraying your last coat add three (3) Ounces to your exiting mix in cup stir well then spray the final finish. Meltdown will have a pronouced melting down effect on any existing orange peel. Be sure to allow for a thinner mix while spraying. You may have to compensate spraying by holding higher and turning the fluid control flow down. then apply your final coat. 


3. Base Coat Clear Gloss Enhancement Effect : Regardless of your brand of coating and your expertise will give even the most seasoned refinisher " THE WOW FACTOR" simply by adding 3 ounces of Melt Down to your existing mix then apply the final coat. The effect of this one simple step is dramatic. Refinished surfaces will cure as if they have been base coated then clear coated. 


4. Elimate Dry Lines, Mottling, Tiger Stripes: During the actual spraying process you sometimes have to stop. The reason can vary from remixing, adjusting equipment,remasking the floor because for some reason the paper and tape that day won't let go of your shoe and every step taken rips masking and you must pause to fix it.  Yes that's frustrating. But not as frustrating as large dry vertical stripe staring you in the face on that back high vertical fiberglass unit your spraying. Or the dry stripe in the clear coat on a wide kitchen counter you just spotted because you couldn't reach and had to walk all the way around dragging everyting with you. Both of these dry spots occured because you had to stop. They are common occurence and leave the finish less than perfect. You either have to buff when your finish or begin again and figure a way to keep a wet edge going the entire time youre spraying. With Melt Down there is no issue at all. Simply mist Melt down across the final finish or add it to your final coat and the entire finish will melt down and gel together.

Recommended Products
Aditives
FAST FLECK - Multispec Accelerator 1 Gal
FAST FLECK - Multispec Accelerator 1 Gal Product ID : FF-1
$39.95  Sale Price: $21.95
Browse more in Multi-Spec category
Click to view
ROCKET UNIVERSAL URETHANE ACCELERATOR 1 QT
ROCKET UNIVERSAL URETHANE ACCELERATOR 1 QT Product ID : ROCK
Price: $26.95
Browse more in Additives category
Click to view
EZ-FLOW LEVELER GLOSS ENHANCER
EZ-FLOW LEVELER GLOSS ENHANCER Product ID : EZ-FLOW
Price: $21.95
Browse more in Additives category
Click to view
TRUE GRIT SLIP RESISTANT PARTICLES "16OZ"
TRUE GRIT SLIP RESISTANT PARTICLES "16OZ" Product ID : TG16
Price: $18.39
Browse more in Additives category
Click to view
image